Error
  • JUser: :_load: Unable to load user with ID: 4232867

Instance 3: Dell e151fp ( equal to Acer FP553 Chassis ) No energy or power on then shutdown briefly

Solution 3: Solder out the faulty C605, C707, C703 capacitor, the defective power UC3842B that is ic resistors R613, R623, R615, faulty transistor Q601, defective diode D604= 1N4148 and fuse F601. Solder the parts that are new into the circuit.

From above examples, no matter how severe fault degree of lcd monitor, the soldering work is obviously tangled up in repairing lcd monitor. You will find the following articles explain the basic soldering to advance soldering technique of the outer lining mounted devices (SMD) on our internet site.

1) Tools for soldering

2) Soldering security and wellness

3) Photos for soldering dry bones on circuit panels
To be aware of building with wire and soldering irons for circuits, check out all of our site best computer chips (Recommended Online site).
But, in the event you went and bought cells that are untabbed spend less, let's explain exactly what has to be done. Firstly, you will need to solder a tabbing strip towards the "sunny-face" of each and every of your cells. There are two main how to try this, both fiddly. You are able to solder the strip right to the mobile with flux or, pre-solder or "tin" each strip and then solder it towards the cellular. The idea is to find a solid link with the solar cellular or it will not move current. Solar ribbon that is tabbing is made of 10-15 micrometers of solder alloy, commonly SN60 (60% tin and 40% lead) covered on copper strip, note this contains lead. I'd get without pre-soldering the tabbing strip when I'm a little lazy. Either way, apply flux towards the the big strips( that is shiny coach bars) on the leading "sunny-face" associated with cell. Lay the tabbing strip over the fluxed bus club sufficient reason for a flat tipped soldering iron, run slowly down the strip. Extra hands are good here. The tab strip will peal straight off if you did a bad job. If done very carefully, the tabbing strip will bond to the bus bar. I suggest practicing on a cell that is broken some free strip to acquire a feel for the soldering. Since you can find frequently two of those on each cell that is solar there exists a lot of fiddly soldering to do. Now would you realise why it is best to buy tabbed cells?

Now to another location action, connecting your tabbed mobile to its mate, the cell that is next. Fundamentally you will end up soldering the free end of the top "sunny-face" tabbing strip to your base associated with next cell and saying the method down your sequence. Therefore, in the event that you would not lay your cells out based on your panel design, (age.g. 3 strings of 8 cells), or whatever your design will be, do that now. Keep a little space of about 1centimeter between each of them. It's a good clear idea to draw a template on some cardboard or Masonite to keep the strings neat and match how big is your array box.

Informacion de contacto

 
TEL.  988 471 969
This email address is being protected from spambots. You need JavaScript enabled to view it.
 

C/San Francico nº25
32400 Ribadavia

This email address is being protected from spambots. You need JavaScript enabled to view it.

Estamos en Facebook
Siguenos en Twitter